![]() ![]() This worked! I went out on saturday and filled the tank, primed it three times and made sure I followed this. Any ideas? I will give it a go again tomorrow and if it acts up it will probably go back to the store. I pretty much adhered to this and dont think I over primed it, but who knows. The only differance in my older speeco and this one is the primer is different, the newer ones have a tiny hole in the center where the older one had a normal primer? Im pretty sure the old one said to push the primer 6 times, these new ones say three times. Ive had this same model of splitter before, a 2005 model, and I never had any problems with it. It was in the low forties so it wasn't too cold. I was about wore out before I started splitting wood. I resorted to pulling the plug off and drying it off about ten times before she finally fired and I burned a tank thru it. She'd fire and run for like a few seconds and then die. I mean like forty five minutes of pull pull pull. ![]() I needed to split more wood and I'll be damned if I had a hard time starting this thing. It did fire up and I split a cord of wood. Then i take it home and I was barely able to get it running. ![]() Since i had not used the splitter at all they gave me a different splitter. I hauled it back to the store and their mechanics could not get it to fire either. It came assembled and ready to go?! But I try to start it and no go. I hauled it home and let it sit until about three weeks ago. I purchased a new Speeco 22 ton splitter with the briggs motor on it in August. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |